2PC Flexible Switchback Dual-Color White & Amber Motorcycle LED Fork Turn Signal Blinkers DRL Daytime Running Light Waterproof Adjustable Stips Bars kit Universal Fit Motorbike (39mm-70mm)

Amazing quality for the price. My GSX-S750 came with these ugly orange turn signals. These cleaned up the look and give a bright light. I didn’t hook up the DRLs because I already have them in the head cowl. I recommend these for anybody looking for a sleek look on their hyper naked or cruiser. The LED function is sequential just make sure you have the proper relay installed.

The media could not be loaded. I can’t comment on the longevity of these but initial review is they exceeded my expectations! Super bright and love the sequential blinker.

The media could not be loaded. Instead of wrapping the lights around the forks of my Royal Enfield Himalayan, I stuck them onto the plastic hand guards, replacing some stick-on reflectors. As the still photo (taken on a fairly sunny afternoon) shows, they are visible in sunlight. I think they make the bike look a little bigger to oncoming traffic, especially since the stock blinkers don't include running lights.As many people have noted, the adhesive on the back of the lights is borderline worthless. I drilled small holes in the hand guards and used small zip-ties to hold the lights in place. If you intend to stick them in place, you might try another layer of a better adhesive tape (I've had good luck with Gorilla Tape).As these lights are not DOT approved for primary turn signal use, I wired them up as supplementary signals, in parallel with the bike's existing turn front blinkers. No problems with the flasher unit, as these lights draw next to no additional current compared to the stock incandescent bulbs.Wiring was a bit tricky because (as many people have noted) the wires are really skinny. The good news is that the skinny wires are inside a pretty robust cable. I crimped/soldered the wires into Molex connectors and used heat-shrink tubing over the connector body and cable. Then I used zip-ties to tie the cable to the hand guard where it emerges from the light body, and zip-tied the connector to a hand guard support. The result of all this is that the cable and connector should be under no stress.The video shows how the lights work in practice. I rather like the way they work with the stock signals. Time will tell how long they last, but given they're solid state and I've reinforced the connections, I expect they will work for at least a few years.

The media could not be loaded. Very nice. Fit and work beautifully. Very bright.

The media could not be loaded. My only complaint was the length of wires straight out the pack isn’t enough so I had to strip and separate. They work and are bright but as we all know the question with products like this is longevity. I’ll update if it fails in 3 days or last me 3 years.Update: first ride and I noticed they start flashing like the 4 ways are on. I don’t know if I need a load resistor or it’s something wrong with the light

Unit flashes on its own, not compatible with factory flasher, cheap ziptie broke after hours of electrical modification to get to flash properly. Do not buy this garbage!

Last set only one of the turn signals actually worked but the running lights were bright as ever so there's that. I thought I was wiring something up wrong for about an hour before I pulled everything apart and realized they didn't even wire in the turn signal to the circuit board. Hopefully one of these 2 work

Works great and looks good I will buy more in the future!